Inhaltsverzeichnis

FTP server receive channel

The FTP server receiving channel enables the connection to services that communicate via FTP protocol. eBiss acts as a server. The receive channel allows you to place messages in the specified message basket (incoming).

Note: FTP Server Receive channel is part of one of the licensed Modules.

Properties

Name Meaning
NameName of the communication channel.
ChanneltypeRe-list the type. (For verification)
communication directionPreferably incoming.
Messagebox Messagebox for incoming messages (incoming)/, must be selected in the corresponding lookup table.
Preset SenderHere you can assign a fixed sender, which is intended for this channel..
Preset RecipientHere you can assign a fixed receiver, which is intended for this channel.
Validation of the senderchecks the sender address of the Interchanges for certain EDI subscribers, if they do not contain the specified subscriber, the message is entered with an error message in the inbound message basket and a corresponding report is generated (only if Required). The test method is selected by means of a combo box (None, Optional, Required, Fixed partner).
Validation of the receipientchecks the recipient address of the Interchanges for certain EDI subscribers, if they do not contain the specified subscriber, the message is placed in the message basket with an error message and a corresponding report is generated (only if required). The test method is selected by means of a combo box (None, Optional, Required, Fixed partner).
PublicBy checking the check mark, the communication channel can be used for all subnodes. However, if a communication channel with the same name is created in the subnode, the communication channel of the subnode is used.
Repetitions in case of errorsIf an error occurs, the number of consecutive reception attempts is determined by entering a value in the corresponding field.
Automatic UnzippingDocuments or attachments are automatically unzipped using the procedure selected in the combo box.

Properties (enhanced)

Name Meaning
Data portFTP data port (preferably 20).
UsernameLogin of the FTP directory.
PasswordPassword of the FTP directory.
SSL behaviorHow to encrypt the connection using SSL. Mode (None, Offer (=Automatic), Explicit, Implicit). In implicit mode, communication is immediately started via an encrypted channel, via another port. More often, the explicit mode is used. The connection is established via the non-encrypted standard ftp port and after the connection is established, but before authentication, it is switched to the encrypted mode.
PFX file of the SSL certificateThe client's private certificate (for client side authentication)
Password file of the SSL certificateThat to the above mentioned. Certificate associated password.
TimeoutSpecification in seconds, with the value' 0' a timeout of 5 minutes is assumed by default.
Use path-based addressingDetermine the sender/receiver depending on the specified path.
Set recipient addressAssigns the path used to the receiver (' yes') or the sender (' no'). The assignment is used for subsequent partner identification if a path-based addressing is required (see above). is desired.
Output Trace