Inhaltsverzeichnis

HTTP send channel

The HTTP send channel enables the connection to services that communicate via HTTP protocol. Messages from the messagebox (outgoing) are transmitted via HTTP via a host whose URL is stored in the channel.

Properties

Name Meaning
NameName of the communication channel.
ChanneltypeRe-list the type. (For verification)
communication directionPreferably incoming.
Messagebox Messagebox for incoming messages (incoming)/, must be selected in the corresponding lookup table.
Preset SenderHere you can assign a fixed sender, which is intended for this channel..
Preset RecipientHere you can assign a fixed receiver, which is intended for this channel.
Validation of the senderchecks the sender address of the Interchanges for certain EDI subscribers, if they do not contain the specified subscriber, the message is entered with an error message in the inbound message basket and a corresponding report is generated (only if Required). The test method is selected by means of a combo box (None, Optional, Required, Fixed partner).
Validation of the receipientchecks the recipient address of the Interchanges for certain EDI subscribers, if they do not contain the specified subscriber, the message is placed in the message basket with an error message and a corresponding report is generated (only if required). The test method is selected by means of a combo box (None, Optional, Required, Fixed partner).
PublicBy checking the check mark, the communication channel can be used for all subnodes. However, if a communication channel with the same name is created in the subnode, the communication channel of the subnode is used.
Repetitions in case of errorsIf an error occurs, the number of consecutive reception attempts is determined by entering a value in the corresponding field.
Automatic UnzippingDocuments or attachments are automatically unzipped using the procedure selected in the combo box.

Properties (enhanced)

Name Meaning
Base-URLEnter the IP address or domain name and the port of the host to which you want to send. e. g. http://localhost:444.
Auth. usernameUser name for server authentication.
Auth. passwordUser password for server authentication.
Auth. domainDomain or IP address of the server for authentication.
MIME-TypeDefines the corresponding HTTP mime type
authenticationSpecifies whether authentication to the server is required. By ticking the checkbox the authentication is activated.
Use simple HTTP send channelThis causes that the system. net. http client is no longer used, but a separate one, which is faster and supports MultiMessages (see below). However, they do not support proxy settings and similar things.
Sending Multiple MessagesSequential processing of the message? A ProcessInstance is created for each transfer and the job involved in processing runs within this ProcessInstance.
Sending multiple attachmentsWhen activating this function, by ticking the check box, all attachments in a mail are written directly into the body of the mail.
Use SSLUse SecureSocketLayer for communication. SSL is a protocol that allows mutual authentication between a client and a server to establish an authenticated and encrypted connection.
SSL protocolWhich TLS version should be used.
TimeoutSpecifies a time in seconds until a timeout occurs.